Adding page bleed is not a feature directly available in Ad Studio. However, a workaround exists by resizing the design and adding a few extra pixels to account for the bleed area. After making the adjustments, you can use the Ruler to mark the bleed zone. This way, you can track where the margins of the design end and where the bleed portions start.
How to Set the Bleed Zone
Create a custom size
- Go to Resize.
- Click on Create, located under the Custom section.
- Set the height and width of the new size by doubling the bleed size¹.
- Type in a size name (optional).
- Click Create custom size.
- Hover over the size, and click Resize.
Set the bleed zone
- Press Shift + R to enable the Ruler.
- Set a ruler for each border, depending on how big you want your bleed zone to be.
These are the recommended values for your bleed zone.
- inch - 0.125
- pixel - 9
- cm - 0.318
- mm - 3.175
Note¹: In this scenario, we've used a Netboard size (580x400 px); after the resize, the size values are 598x418 px, and each border has a 9 px length.